User guide

FIGURE 35
FIGURE 34
EB 360
61
EB 360
60
When using the EB 360 with
brushes on carpets and rugs
(especially fine velour), set the
Kobold VK 140 suction power to
automatic setting A
(FIGURE 33).
If the EB 360 joint is set vertical,
the brushes are stopped to prevent
damage to surfaces.
Anti-damadge block
If you accidentally suck up something
big or if the mattress lining is a little loose
and the suction power of the Kobold VK 140
is too high, the EB 360 automatically cuts-
out while the Kobold VK 140 continues to
operate at the set power.
The blinking green operating light (on)
indicates a blockage. Switch off the
appliance, remove the plug from the mains
socket and remove the trapped object from
the EB 360. Switch the Kobold VK 140 on
again at minimum power level “1”.
Kobotex for stain removal
If there are still some stains left after
cleaning with Kobosan active or with
Lavenia, use Kobotex to remove them.
Read the instructions given on the back of
the Kobotex container. Apply Kobotex
directly to the stain, rubbing it in from the
outside of the stain inwards.
Continue this action until no visible traces
are left on a clean cloth after rubbing it on
the stain. If left for a long time, certain
stains can permanently discolour carpets
and rugs. We recommend cleaning stains as
soon as they form, as rapidly as possible.
Before removing stains with Kobotex,
test its effect on a small portion of the
carpet. Kobotex will not remove paint stains
or other substances containing solvents.
EB 360
Assembly & Use on hard floors
To clean hard floors the EB 360 should be
fitted with the bristle brushes.
We recommend to use the soft function
on hard floors: the noise will be reduced by
equal performance.
Dust vacuuming
on hard floors
Switch on the Kobold VK 140 and operate,
the green operating light on the EB 360
indicates that the appliance is on.
In this function we recommend to set the
Kobold VK 140 suction power to automatic
setting A or
.
For cleaning coarse dirt we recommend
to vacuum with a backwards movement
of the EB 360 (see
FIGURE 37).
Do not use EB 360 on delicate or PVC
hard floors without the soft function
activated.
FIGURE 36
FIGURE 33
FIGURE 37
Assembly & Use Assembly & Use