User guide

VK 140
37
VK 140
36
Assembly & Use Assembly & Use
To get the Kobold VK 140 ready for use, fit
the EB 360 as shown in the picture.
(FIGURE 3)
To this, guide the plug of the mains cord
through the rod handle.
(FIGURE 4)
Before using the Kobold VK 140 for the first
time, it is necessary to insert the mains cord
within the rod handle, you do not need to
remove it unless you have to change the
cable.
Slide it down from top to bottom of the rod
handle and insert it in the appliance until
you can hear a click.
(FIGURE 5)
 Kobold VK 140 with EB 360
Assembly & Use
By winding the mains cord, make sure that
it is rolled in the same direction as shown in
the picture.
(FIGURE 6)
 Pay attention to possible damages to the
appliance or the connecting cable when
winding it up.
 Check that the mains cord can slide
freely through the handle when telescoping.
 Do not hold on to the mains cord during
telescoping.
Wind the connecting cable around the two
hooks which are designed for this purpose.
(FIGURE 7)
 Remove the plug from the socket before
winding up the mains cord
 Check that the mains cord can slide
freely through the handle when telescoping.
 Never try to take out the rod handle from
appliance.
 Only unplug the appliance by pulling on
the mains plug, and never by pulling on the
mains cord.
 Never carry the appliance with the
mains cord.
 Never run the Electronic brush over the
mains cord or other cable lying on the floor.
FIGURE 6
FIGURE 7
FIGURE 4
FIGURE 5
FIGURE 3