Installation Guide

INSTALLATION THROUGH A MASONRY CHIMNEY (SEE FIGURE

Step 1- Position appliance: Locate the appliance in accordance with the appliance

manufacturer’s instructions and clearance specifications. Mark the center of the hole where

the pipe is to penetrate the masonry chimney.

Step 2- Prepare the wall opening: If the masonry chimney has an existing 6” terra cotta

thimble, please skip to step #3. It will be necessary to break out the masonry around the

location of the pipe center line mark to a diameter 6 inches.

Step 3- Attach the Masonry Adapter: Attach the interior side of the Masonry Adapter (N)

to the take-off on the existing liner components (O). Place the take-off through the hole in

the masonry chimney and attach the clamping band from the take-off around the body of the

pre-installed tee/flexible liner system. The Masonry Adapter should now be flush with the

exterior side of the chimney.

Step 4- Pipe Installation: Install a Stove Adapter (H) or Stove Adapter Tee (A) by first

applying high temperature sealant onto the appliance flue collar and then secure the Stove

Adapter with a minimum of (3) #8 x ½” self-drilling screws. Connect sections of pipe (B)

together using the band clamp located on the female side of the outer pipe. A 90 degree

elbow (M) will be utilized to turn the pipe into the horizontal position. An adjustable slip

section pipe can now be used to connect from the elbow to the Masonry Adapter (N).

INSTALLATION TO AN EXISTING 2100 FACTORY BUILT

CHIMNEY (SEE FIGURE 5)

This type of installation is for connecting SBI Venting Division Pellet Vent Pipe to an existing

ceiling supported 2100 insulated chimney.

Step 1- Inspection: Remove any existing connector pipe from the appliance to the

Universal Adapter that is already installed in the Support Box. Visually inspect the interior

of the existing 2100 insulated chimney components (Q) for cleanliness and structural

integrity. All creosote must be removed from the existing chimney prior to connecting the

pellet vent pipe.

Step 2- Install Adapter: Install the appropriate sized 2100 insulated chimney Adapter (P)

(5”, 6”, 7”, or 8”). The Chimney Adapter will be connected to the Universal Adapter by a

minimum of three #8 x ½” self-drilling screws.

Step 3- Pipe Installation: Install Stove Adapter (H) or Stove Adapter Tee (A) by first

applying high temperature sealant onto the appliance flue collar and then secure the Stove

Adapter with a minimum of (3) #8 x ½” self-drilling screws. Connect sections of pipe (B)

together using the band clamp located on the female side of the outer pipe. An Adjustable

Length Pipe (Slip Section) can now be used to connect from the last standard pipe to the

Universal adapter.