User's Manual

SPITFire
™
HD GEN II
4 5
CONTROLS AND ADJUSTMENTS
Battery Installation
Remove the battery compartment cover using the included
tool or a coin. Install and orient the CR2032 battery so the
positive (+) side faces out, then replace the cover. When
replacing the cover, be sure it is fully screwed down with
the o-ring seal in place.
Powering Up
To turn the Spitfire
™
HD Gen II on/off:
Press the up (+) or
down (-) button to turn
on the illumination.
Press and hold the up
(+) or down (-) button
for three seconds to turn
illumination off.
Power / Illumination Buttons
Illumination Adjustments
The Spitfire
™
HD Gen II sight offers 12 brightness
settings, the lowest two settings being ultra-low for use
with night-vision equipment. Adjust the brightness by
tapping the up (+) or down (-) button.
Note:
The reticle will blink three times if the up (+) button is
pressed at the highest brightness setting, or if the down (-) is
pressed at the lowest brightness setting. The three blinks at the
lowest level will only be visible when using a night-vision device.
The Spitfire
™
HD Gen II will return to the last used
brightness setting when turned on.
Auto Shut-Off
The Spitfire
™
HD Gen II features an auto shut-off feature
to extend battery life when not in use. If you forget to turn
off the Spitfire
™
HD Gen II, it will automatically shut off
14 hours after the last button press.
Reticle Focus
The Spitfire
™
HD Gen II prism scope uses a fast-focus
eyepiece designed to quickly and easily provide a sharply
focused reticle.