User`s guide

3.) CONNECTING THE SOUNDSTATION VTX

1000

TO A VORTEX DEVICE

In order to send and receive audio to the SoundStation VTX 1000 Interface Module, you need to observe the

following wiring procedure:

1.) Connect the Auxiliary Output of the Interface Module to a line level input of a Vortex device.

2.) Connect Output B the Vortex device to the Auxiliary Input of the Interface Module. By default,

Outputs A, B, and C of the Vortex device is a mix-minus version of the Input B signal.

The drawing below illustrates the use Input B and Output B of a Vortex EF2280 to connect to the Interface

Module.

If you are using the Polycom Instant

Designer™ software, connect the Vortex inputs and outputs selected by

the Instant

Designer to the SoundStation VTX 1000 interface Module.

WIRING