User manual

5
5.2 Operating mode “touch” 6 Clean and maintenance
• A proper maintenance of the instrument guarantee its
good life
Touch
Picture 4
OFF
• Disconnect power suplly cable during maintenance.
• Do not spray the spray cleaner inside the instrument.
• Use only mild detergent and do not contain abrasives
.
Make sure that the knob for adjusting the speed of
agitation is positioned to a minimum. Place the instrument
on a stable surface and connect it to the mains.
• Set the main switch to the
TOUCH right.
• Turn the control knob until the desired speed is set.
• If a tube is pushed vertically on head rotation, it starts to
work and the power led lights up.
• To switch off, switch the master switch in the middle
position (OFF). The LED turns off and the power is off.
• Before proceeding with any cleaning or
decontamination, the user must ensure that the method
used does not damage the instrument.
• Wear suitable protection when cleaning with Chemicals
• If the instrument must be returned for service, it is
necessary to provide for proper cleaning and possible
decontamination by pathogens of the same. You should
also put the instrument in its original packaging to send it
to repair service.