Operation Manual

RIFLESCOPE

Indexing Adjustment Dials with Zero Reset

Crossfire II riflescopes feature windage/elevation dials that allow you to

re-index the zero indicator after sight-in without disturbing your settings.

Though not required to do, this process will allow you to quickly return to

your original zero if temporary corrections are dialed in the field. Reset the

windage and elevation dials in this way:

1. Remove the outer cap.

While firmly holding the

dial, loosen and remove

center screw.

2. Lift dial off of scope.

Orient dial to reposition

the zero mark on the index

line.

3. Install dial and reinstall

and tighten center screw

while firmly holding the

dial..

mAintenAnce

The fully waterproof and fogproof Vortex Crossfire II riflescope requires

very little routine maintenance other than periodically cleaning the

exterior lenses. The exterior of the scope may be cleaned by wiping with a

soft, dry cloth.

Cleaning

• Be sure to blow away any dust or grit on the lenses prior to wiping the

surfaces.

• Using your breath, or a very small amount of water or pure alcohol, can

help remove stubborn things like dried water spots.

All components of the Vortex Crossfire II riflescopes are permanently

lubricated, so no additional lubricant should be applied.

Lubrication

When cleaning the lenses, be sure to use products, such as the Vortex Fog

Free cleaning products or Lens Pen, that are specifically designed for use

on coated optical lenses.

Note: Other than to remove the turret caps, do not attempt to disassemble

any components of the riflescope. Disassembling of riflescope may void

warranty.

If possible, avoid exposing your Vortex riflescope to direct sunlight or any

very hot location for long periods of time.

Storage