User's Manual

TimeLord Master Clocks
Operating and Installation Instructions
Issue 2.0
2-5
Function ‘Serial 1 Setting Mode’.
‘^’ to select, ‘+’ or ‘-’ to change.
Function ‘Relay Setting Mode’. ‘^’
to select, ‘+’ or ‘-’ to change.
Function ‘IRIG Setting Mode’. ‘^’ to
select, ‘+’ or ‘-’ to change.
Function ‘System Setup’. ‘^’ to
chang the system seeting.
Normal time display
Function ‘Zone Setting Mode’. ‘^’
to select, ‘+’ or ‘-’ to change.
Zone Setting Mode selected, with
location 2 flashing. See page 6-1.
Serial 1 Setting Mode selected,
with code flashing. See page 7-1.
Relay Setting Mode selected, with
setting flashing. See page 8-1.
IRIG Setting Mode selected, with
type flashing. See page 10-1.
Brightness Mode selected, with
brightness flashing. See page 2-8.
Programming menus cont.
Function ‘Serial 4 Setting Mode’.
‘^’ to select, ‘+’ or ‘-’ to change.
Serial 4 Setting Mode selected,
with code flashing. See page 7-1.
Function ‘EBU Setting Mode’. ‘^’ to
select, ‘+’ or ‘-’ to change.
EBU Setting Mode selected, with
type flashing. See page 11-1.
Function ‘Impulse channel 1 Setting
Mode’. ‘^’ to select, ‘+’ or ‘-’ to change.
Impulse channel 1 Setting Mode selected,
with status flashing. See page 12-1.
Function ‘Impulse channel 2 Setting
Mode’. ‘^’ to select, ‘+’ or ‘-’ to change.
Impulse channel 2 Setting Mode selected,
with status flashing. See page 12-1.
‘Serial 2 Setting
Mode’ will only
appear on .S2
& .S4 versions.
‘Serial 3 Setting
Mode’ & ‘Serial 4
Setting Mode’ will
only appear on
.S4 versions.
‘Impulse Channel
1 Setting Mode’ &
‘Impulse Channel
2 Setting Mode’
will only appear
on -02 impulse
versions.
‘EBU Setting
Mode’ will only
appear on
EBU-OUT
versions.
‘IRIG Setting
Mode’ will appear
on all versions, but
only be usable on
-IRIG-OUT
versions.