User's Manual

Issue 2.0
TimeLord Master Clocks
Operating and Installation Instructions
2-8
System Set-up
The system set-up menu contains general set-up options for
the TimeLord Master Clock. The table below details the
available options.
w482 Timecode output
As shown in the table above, the w482 timecode output port
may be set to output either w482 timecode or unmodulated
MSF, DCF or HBG timecodes. The MSF, DCF & HBG outputs may
be set to pulse high or low as required (MSF, DCF & HBG pulse
high, -MSF, -DCF & -HBG pulse low). The L48 option
implements longer w482 code pulse lengths for use with older
400 series digital clocks. The S48 option implements shorter
than standard w482 code pulse lengths.
Normal time display
Function ‘System Setting Mode’.
Press ‘^’ to select.
Function ‘Time Setting Mode’.
Press ‘+’ eight times to move to
system setting mode.
Normal time display
Brightness setting mode, with
brightness flashing. Use ‘+’ and ‘-’
to alter brightness and ‘^’ to store.
unempu-tesmetsyS
edoC noitcnuF snoitpO
irBssenthgirByalpsiD)tsemmiD=1(.4-1
tuoepyttuptuo284w,FSM-,FCD-,FSM,FCD,284w
GBH-,GBH,84S,84L
AVerawtfosTimeLord
noisrev
BVerawtfoskrowten
noisrev
erawtfossihtnidelbasid(
)noisrev
GnEylnoesuyrotcaf
w482 timecode output setting mode,
with w482 flashing. Use ‘+’ and ‘-’ to
alter output type and ‘^’ to store.
TimeLord software version. Press
‘^’ to continue.
Network software version
(disabled in this software
revision). Press ‘^’ to continue.
Factory use only. Press ‘^’ to
continue.
If your TimeLord
is fitted
with NTP,
EBU, S2, S4
or .IMP
options, you
may need to
press the ‘+’
switch more
than 8 times.