Owner manual

P/N: 007079
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN04 v1.0 BattRelocRoutng(7079v1.0)
®
ENGINEERING, LLC
1650 PACIFIC AVENUE • CHANNEL ISLANDS, CA 93033-9901 • [phone]
FAX [phone] • www.vortechsuperchargers.com • M-F 8:00 AM - 4:30 PM PST
3
vertical tabs off of the hold-down bracket
depending on your battery.) Secure the sup-
plied battery hold-down bracket using 3/8-16
nuts and washers. Attach the clear hose end
to the plastic 90° fitting mounted on the side of
the battery box. (Refer back to Fig. 5.)
P. Trim the power and ground cables to desired
length, cut back the insulation and install the
supplied battery end terminals. Use the sup-
plied 1-1/2" heat shrink tubing to cover any
bare metal surfaces on the cable/terminal
connections. (See Fig. 6.)
Q. Connect the supplied battery terminals to the
battery. Install the supplied battery box lid and
secure with the supplied washers and wing
nuts. Using a hacksaw, cut the all-thread to
where there is 3/4" of thread exposed above
the wing nuts. (See Fig. 7.)
R. Reinstall the trunk carpeting and interior trim
pieces. From beneath the vehicle, secure the
end of the clear hose away from the exhaust
and any moving or sharp components. (See
Fig. 8.)
BATTERY RELOCATION AND CABLE ROUTING, cont’d.
Fig. 6
Fig. 7
Fig. 8