Manual

P/N: 4FR020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
23AUG04 86-93 4V Mus. Cobra(4FR v3.1)
P/N: 4FR020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
23AUG04 86-93 4V Mus. Cobra(4FR v3.1)
26
Fig. 10-m / (Mach 1 Models Only)
SUPPLIED
BRACKET
FACTORY
MANIFOLD
COVER BOLT
Fig. 10-k / (Mach 1 Models Only)
SUPPLIED
BRACKET
SUPPLIED
BRACKET
SUPPLIED 1/4-20 SCREWS,
NUTS, WASHERS
Fig. 10-l / Modied Shaker Bracket w/Vortech
Brackets Attached (Mach 1 Models Only)
5. Remove the front passenger's side intake
manifold cover bolt. (See Fig. 10-m.) Locate
the driver's side relocation bracket in between
the bottom of the modied steel air scoop base
and the front passenger's side intake manifold
cover bolt. Re-install the intake manifold cover
bolt through the new bracket. Mark and drill a
5/16" hole in the modied steel air scoop base.
Permanently attach the relocation bracket to
the modied steel air scoop base using the
1/4-20 x .75" screw, nut and washer. Tighten
the two factory screws securing the steel
air scoop base at the rear of the intake
manifold.
6. Re-install the modied aluminum shaker scoop
assembly onto the modied steel air scoop
base using the factory hardware and rubber
grommets. Ensure the assembly alignment by
carefully closing the hood. Adjust the scoop
base if necessary.
Referring to Figs. 10-k, 10-l, attach the driver's
side relocation bracket to the alternator and
the underside of the modied steel air scoop
base and align. Mark and drill two 5/16" holes
in the modified scoop base. Permanently
attach the relocation bracket to the modied
steel air scoop base using the 1/4-20 x .75
screws, nuts and washers.
10. AIR INLET, cont'd