Users Manual

21
English20 English
Unit is not plugged in. Plug Power Cord into electrical outlet.
Household circuit breaker / ground fault interrupter has tripped or
blown a fuse. Reset circuit breaker / ground fault interrupter, or replace
fuse (See IMPORTANT SAFETY INSTRUCTIONS).
The unit has overheated. Automatic Safety Shut-Off has initiated (See
RESETTING YOUR VORNADO HEATER).
Unit is damaged or in need of repair. Cease usage and unplug.
Contact Consumer Service for assistance.
Check to see if the unit is locked. If lock icon is lit, hold down on icon
(for 3 seconds) until the light turns off. If the unit is unlocked and still
does not power off, unplug unit and contact consumer service.
Ensure unit is set to High Heat and thermostat is set to highest
temperature setting.
Close all doors and windows to contain heat.
Unit fails to
power on.
Unit fails to
power off.
Unit is not
producing
sufficient
amount of heat.
Troubleshoot
Allow the unit to fully circulate the heat throughout the room, may take
several minutes.
Power off and unplug the unit. On the bottom of the unit, there is a
gray tip over switch. Push in 4-5 times ensuring it is not stuck. Set unit
down on flat surface. Be sure power cord is not under unit. Plug unit in
and power on. Turn to highest heat setting.
Make sure the CSR is within 15 feet of unit.
Reset the CSR remote to re-establish connection (See CRIB SENSOR
REMOTE).
Replace batteries. Note: Even when Sensa is powered off, to maximize
battery life, it is recommended you turn the CSR remote off (slide
switch to the off position).
Unit is not
producing
sufficient
amount of heat.
(cont.)
Unit power on
but there is no
heat.
CSR remote will
not sync.