Use and Care Manual

7
English
1
2
3
4
1
VH2 Controls
Power On/Off
Illuminated when the unit is On.
Thermostat
Allows you to select your desired
comfort level.
For fan only use - select the Fan Only
setting and press High on the Fan
switch.
Fan
In the Auto position, the fan will cycle
on and off with the heating element.
In the High position, the fan will run
continuously.
VH102 Controls
Power On/Off
Illuminated when the unit is On.
Thermostat
Allows you to select your desired
comfort level.
For fan only use - select the Fan Only
setting and press High on the Fan
switch.
Fan
In the Auto position, the fan will cycle
on and off with the heating element.
In the High position, the fan will run
continuously.
1
2
3
4
1
2
3
4
Controls
2
3
4
Heat
(I) Low Heat 750 watts
(II) Medium Heat 1125 watts
(III) High Heat 1500 watts
How To Use
Getting Started
Using your Vornado Heater is easy. Just follow these simple steps.
1. Position your heater so the vortex beam of warm air is directed
across the room, unobstructed. Position it in a location that
is representative of the room temperature. Avoid areas of
temperature extremes such as cold drafts and heat registers (refer
to IMPORTANT INSTRUCTIONS for safe placement).
2. Plug power cord into standard wall outlet.
3. Set Power switch to On.
4. Select Heat setting.
5. Set Thermostat to the highest setting. When the room reaches
the desired comfort level, turn the Thermostat knob slowly
counterclockwise until the heat cycles off (easier to detect when
Fan is set to Auto).
Heat
Low Heat 750 watts
High Heat 1500 watts