User manual

VOPTech GoIP User Manual

C. H.323 ID

H232 ID is used to verify the account. Users can set this parameter according to the

requirements of the service provider.

D. Default Voice Gateway

This parameter is used to find the proper Gatekeeper or IP address of the equipment of the

callee. Enter the IP address, such as 192.168.2.197, or domain name, such as gk.yourisp.com.

If the softswitch system uses the non-standard port (1719 and 1720), you can add the detailed

port number at the end of the IP address or domain name of the Gatekeeper. For example, if

the port number is 7300, the IP address is 192.168.2.197:7300 and the domain name is

gk.yourisp.com:7300.

Under the direct connection mode, the GoIP will forward all calls to the VoIP network to this

address.

Note: The value of this parameter must be standard ASCII characters (enter characters under the English input

mode).

3.5.1.2 Gatekeeper

Under the Gatekeeper mode, the GoIP operates in the H.323 register status. When you register

through the H.323 protocol, select “H.323 Terminal” in “Terminal Type”, as shown in the

above figure. The registration mode involves the Gatekeeper and direct connection (the direct

connection mode is used for calls over the IP address). When all lines use one number, select

the single server setting mode. When all lines use different numbers, select the line setting

mode. When you select the line setting mode, each line can be registered to different servers.

The setting parameters are as follows: