User manual
DVR User Manual
27
If the threshold value is reached, the system will trigger the Disk Full Alarm.
Click ―Apply‖ to save settings; Click ―Exit‖ to exit the current interface.
4.5.4 Alarm Out
To setup alarm out:
Enter into MenuSetupAlarm out tab. Refer to Fig 4-23:
It is an inbuilt alarm output device. To setup Buzzer:
Checkmark Buzzer and set buzzer alarm hold time. This would trigger the buzzer
when the system is in alarm. Fig 4-23 Alarm Out
4.6 Network Configuration
Network configuration includes five submenus: network, sub stream, Email, server and
other settings. Network settings must be configured if DVR is used for monitoring over
network.
4.6.1 Network
Step 1: Enter into MenuSetupNetworkNetwork tab. Refer to Fig4-24:
Step 2: HTTP port: the default value is 80. If the value changed, you need to modify
the IP address in the IE address .i.e. if HTTP port is set to 82 and IP address is,
192.168.0.25, then you shall input IP address as
http://192.168.0.25:82 in IE browser.
Server port: Communication port.
Step 3: Connect internet. If you have a DHCP server running and would like your DVR
to automatically obtain an IP address and other network settings from that server, check
the checkbox beside "Obtain an IP address automatically". Fig 4-24 Network Configuration-Network
VOOK