User manual

DVR User Manual
26
Step8: Select ―All‖ to setup all channels with the same parameters.
Step9: Click ―Apply‖ button to save the settings.
Step10: Enter into Schedule tab. The setup steps for schedule for motion based
alarm are similar to normal schedule setup; Please refer to 4.4.1 Schedule for
details.
This step is very important for motion based alarm. Even if you have enabled the
motion based alarm for all channels and setup the trigger, you will not see the
result of motion based alarm if no schedule is added.
If you have set the schedule for motion based recording in the same timeline,
recordings can also be triggered. Fig 4-20 Motion-Schedule
4.5.2 Video Loss
Step1: Enter into MenuSetupAlarmVideo Loss tab. Refer to Fig 4-21:
Step2: The setup steps of video loss trigger are similar to alarm handling. You can refer
to Chapter 4.5.1 Motion –Step 4 for more details.
Step3: Click ―Apply‖ button to save the setting; click ―Exit‖ button to exit the current
interface.
Fig 4-21 Video Loss
4.5.3 Other Alarm
This tab gives a choice to configure alarm for Disk Full, IP Conflict, the Disconnect
event, Disk Attenuation or Disk Lost.
Step1: Enter into MenuSetupOther alarm tab. Refer to Fig 4-22:
Step 2: Use the dropdown menu and select the event or the alarm.
Step 3: Check the required trigger options.
If the selected event is ―Disk Full‖, then use the drop down box for ―Disk Shortage
Alarm‖ to choose a threshold value for remaining HDD space. Fig 4-22 Other Alarm
VOOK