User manual

DVR User Manual
25
Step3: Enter into Alarm Handling tab and select hold time and then click Trigger
button. A dialog box will pop-up as Fig 4-18:
Step4: Enter into alarm tab to select the options to handle alarm and then click OK.
Buzzer: If selected, the local inbuilt buzzer would be activated on an alarm.
Show Full Screen: If selected, there will pop up the chosen channel on the monitor
on an alarm trigger.
Email: If you select this option, the DVR will send an email alert to the
preconfigured email address in case of a motion based alarm from the particular
input. Fig 4-18 Motion Alarm – Trigger
Snap: If selected, the system will snap images of the checked channels on an alarm
and save them in the HDD automatically.
Step5: Enter into To Record tab. Select recoding channels. It would be recorded in
case of an alarm. Click OK button to save the setting.
Step6: Enter into To PTZ tab. Set preset, cruise and track options for a PTZ in case of
a motion based alarm. Single or multiple PTZ units could be programmed to perform
this function on the same alarm.
Step7: Click ―Setting‖ button under the Area to display the following picture as
shown in Fig 4-19:
In the Area tab, you can drag slide bar to set the sensitivity value (1-8). The higher the
value is the more sensitive it is to motion. Since the sensitivity is influenced by color
and time (day or night), you can adjust its value according to the practical conditions. Fig 4-19 Motion-Area
Left click the grid and drag to delete area. Drag again to add area. Click icon to set the whole area as detection area. Click icon
to clear the set detection area. Click icon to test the sensitivity as per the local conditions. Once motion is sensed, it displays a figure
icon. Click icon to save the setting. Click icon to exit the current interface.
Note: Prior to setting motion detection field it is recommended that you click icon to clear the existing field and set afresh.
VOOK