User manual

Digital Video Recorder User Manual
12
Item Name Function
11 Playback Control Button To control playback, Fast forward/rewind/stop/single frame play.
12 AUDIO Button To enable audio output in live mode.
13 Auto Dwell Button To enter auto dwell mode.
14 BACKUP Button To enter backup mode.
15 PTZ Control Button To control PTZ camera, Move camera/ZOOM/FOCUS/IRIS/SPEED control.
Operation processes with remote controller to control multi-DVR
The default device ID of the DVR is 0. It’s not necessary to reset the device ID when a remote is to be used to control a single DVR.
However when controlling multiple DVRs with multiple remote controllers, the user would need to configure the device ID, please refer to
below steps:
• Activate remote controller to control the DVR: Turn the IR sensor of the remote controller towards the IR receiver on the front panel,
press the number key 8 twice on the remote, then input device ID of the DVR to be controlled (Range from: 0-65535; the default device
ID is 0) press ENTER to confirm.
• User can check the device ID of a DVR from System SetupÆBasicÆDevice ID. User can also set multiple DVRs with the same device
ID however this can cause interference if the DVRs are kept close to each other.
2.5 Control with Mouse
2.5.1 Connect Mouse
It supports USB mouse through the ports on the rear panel.
If mouse is not detected or doesn't work, check below steps:
1. Make sure the mouse is plugged in the USB mouse port not the USB port on the front panel 2. Change a mouse to try
2.5.2 Use Mouse
In live:
Double-click left button on one camera to be full screen display. Double-click again to return to the previous screen display.