PEDAL POWER ISO-5 User’s Manual www.voodoolab.
Copyright ©2009-2010 by Digital Music Corporation. This publication is protected by copyright and all rights are reserved. No part of it may be reproduced or transmitted by any means or in any form without the express prior consent in writing from Digital Music Corporation. Voodoo Lab and Pedal Power are trademarks of Digital Music Corp. rev 1.
TABLE OF CONTENTS Introduction . . . . 2 Unpacking . . . . 2 Connections . . . . 3 DC Power Cables . . . 4 Boss Pedals . . . 4 Line 6 Modeling Pedals . . 4 TC Electronic . . . . 5 Eventide . . . . . 5 Additional Cables . . . 5 Isolation . . . . 6 Specifications . . . . 7 Warranty . . . . . 8 How to Reach Us . . . 9 . .
Introduction Pedal Power ISO-5 is an isolated power supply for powering guitar pedal effects and accessories. Its compact design is perfect for smaller pedalboards, rack shelves, or even as an additional power supply for larger boards. Pedal Power ISO-5 features five independent, filtered and regulated output sections, which will keep even the most sensitive vintage and boutique analog pedals dead quiet.
Connections Pedal Power ISO-5 is powered directly from mains using the supplied AC line cord. This is a standard computer-type IEC line cord, so it’s easy to obtain a replacement or different length. Important: Pedal Power ISO-5 is manufactured to operate from a specific supply voltage (100V, 120V or 240V) which is marked on the bottom of the unit. Attempting to operate at the wrong voltage may cause permanent damage. 1) 9V outputs (3).
DC Power Cables The Pedal Power end of each supplied DC power cable has a black barrel connector. The other end has either another identical barrel connector (center negative), a 5.5x2.5mm red barrel (center positive) or a 3.5mm mini-plug (tip positive). Use the standard right-angle black barrel connector cables with most common 9V battery operated pedals. Occassionally, a right-angle connector will not properly fit the power jack, so a cable with straight connector is also provided.
TC Electronic TC Electronic’s Nova pedals such as the Delay, Modulator and Reverb are powered from the high-current 12V output using a standard black 5.5x2.1mm barrel cable. This does not match the rating of the supplied TC Electronic adapter, but does correctly power these pedals. Other TC Electronic pedals which can be powered from a 9V battery, such as the Classic series, can operate from any of the 9V outputs.
Isolation Pedal Power ISO-5 has has five isolated output sections. This is sometimes referred to as “galvanic isolation” and means that there is no direct electrical connection between each output. Similarly, when you power your effects with batteries, they are also isolated because there is no electrical connection between the batteries. Most power supplies are not isolated. Their output jacks are simply bussed together or use a daisy chain cable.
Specifications Input: IEC connector 120V 50/60Hz (North America model) 100V 60Hz (Japan model) 230V 50/60Hz (Europe/Australia model) Model and input power are marked on the bottom of unit. Outputs: 5.5x2.1mm barrel connectors center negative Short circuit protected. 9VDC (3) - 100mA 9 and 12VDC - 300mA 18VDC - 100mA Physical: 4.9” wide x 3.4” deep x 1.8” tall (124 x 86 x 44 mm) 1.24 lbs (0.
WARRANTY North America Only Voodoo Lab warrants this product against defects that are due to faulty material or workmanship for a period of five years from the date of original retail purchase. This warranty does not include damage to the product resulting from accident or misuse. This warranty is given to the original purchaser only and it is not assignable to any other person.
