User manual

EFX MkIII+ Audio Controller User Manual 10
Press theྜ PS-2 switch to store a new channel in memory. The display will show str (store) for a moment
and the LED above the PS-2 switch will stop flashing.
Press theྜྷ PS-3 switch(NUM, number) to set an EPL or ESW controller number. The
display will show the current EPL or ESW controller number.
Press/hold theྞ BANK UP or BANK DOWN switches to select an EPL or ESW controller number from 000.
through 127. or ---.. The LED above the PS-3 switch will flash.
Press theྟ PS-3 switch to store a new EPL or ESW controller number in memory.
The display will show str (store) for a moment and the LED above the PS-3 switch will stop flashing.
The EFX MkIII+ has an additional re verse function that reverses the control value.ྠ
Press the PS-4 switch(TGL, toggle) to reverse an EPL or ESW
control value. The display will show the current EPL or ESW
control value mode.
The table below shows the control value of the normal and rever se modes.
Expression Pedal (EPL) External Foot switch (ESW)
Normal Reverse Normal Reverse
Minimum Position 0(0x00)
127 (0x7F) Open 0 (0x00) 127 (0x7F)

 
Closed 127 (0x7F) 0 (0x00)
Maximum Position 127 (0x7F)
0(0x00)
Press theྡ BANK UP switch to t oggle between normal and reverse. The LED above the PS-4 switch will
flash.
Press theྡྷ PS-4 switch to store the reverse function in memory. The display will show str(store) for a
moment and the LED above the PS-4 switch will stop flashing.
Cable Wiring for Expression Pedal
The cable required is a stereo (TRS) to two mono 1/4" phone plugs. Connect the tip(stereo plug) to the pedal
input, ring to the pedal out put and sleeve to ground on all 3 plugs.
Cable Wiring for External Foot Switch
The cable required is a mono (TS) to a mono(TS) 1/4" phone plugs.