Installation Sheet

1. Cut (Ø2 3/8”) hole in the ceiling
(Minimum ceiling thickness 1/4”)
2. Pull building supply wires through
ceilling cutout and open fixture box door.
Remove desired housing knockout and feed
building wires into housing using
appropriate connector.
Fig. 1
Fig. 2
3. Connect fixture wires to building wires
Connect each supply wire with appropriate dirver wire
connector
Installer tip: The fixture features electric low voltage
dimming capabilities.
ROUND: CUT OUT
Fig. 3
Ø2 3/8”(Ø60mm)
Fig. 4
4. Place driver box into ceiling
Fig. 5
Fig. 6
Instructions
© VONN Lighting,2020
www.vonn.com
Cable to fixture
Power supply
Green / Ground
Black / Hot
White / Neutral
5. Insert fixture body upward to clip into ceiling
350°
90°