Installation Sheet

1. Cut (Ø2 3/8”) hole in the ceiling
(Ceiling thickness 1/4” to 3/4”)
2. Pull building supply wires through
ceiling cutout and open fixture box door.
Remove desired housing knockout and feed
building wires into housing using
appropriate connector.
Fig. 1
Fig. 2
3. Connect fixture wires to building wires
Connect each supply wire with appropriate driver wire
connector
ROUND: CUT OUT
Fig. 3
Ø2 3/8”(Ø60mm)
Green / Ground
Black / Hot
White / Neutral
Power supply
Cable to fixture
Dim+purple(0-10V)
Dim-gray(0-10V)
Fig. 4
5. Connect the DC wire. Place DC wire into the ceiling. Remove
fixture cover. Insert fixture into ceiling
Fig. 5
Fig. 6
6. Tighten screws and lock fixture in place
Instructions
© VONN Lighting,2020
www.vonn.com
4. Place driver box into ceiling
Top View
(Above Ceiling)
Installer tip: The fixture features electric low voltage
(ELV or 0-10V) dimming capabilities.