Installation Sheet

1. Cut (L3 5/8” x W1 5/8“) hole in the ceiling
(Minimum ceiling thickness 1/4”)
2. Pull building supply wires through
ceilling cutout and open fixture box door.
Remove desired housing knockout and feed
building wires into housing using
appropriate connector.
Fig. 1
Fig. 2
3. Connect fixture wires to building wires
Connect each supply wire with appropriate dirver wire
connector
Installer tip: The fixture features electric low voltage
dimming capabilities.
SQUARE: CUT OUT
Fig. 3
L3 5/8” x W1 5/8”
(92mm x 42mm)
Fig. 4
4. Place metal box into ceiling
Fig. 5
5. Remove fixture cover by prying open small
screwdriver
Fig. 6
6. Insert metal tube in ceiling hole. Use one screw to fix the
body to the ceiling on one side. Rotate the fixture lower
part 180° and install other screw to secure fixture body
Instructions
© VONN Lighting,2020
www.vonn.com
Cable to fixture
Power supply
Green / Ground
Black / Hot
White / Neutral
180°