Installation Sheet

1. Cut (Ø5/8”) hole in the ceiling

(Minimum ceiling thickness 1/4”)

2. Pull building supply wires through

ceilling cutout and open ﬁxture box door.

Remove desired housing knockout and feed

building wires into housing using

appropriate connector.

Fig. 1

Fig. 2

3. Connect ﬁxture wires to building wires

Connect each supply wire with appropriate dirver wire

connector

Installer tip: The ﬁxture features electric low voltage

(ELV or 0-10V) dimming capabilities.

ROUND: CUT OUT

Fig. 3

Ø5/8”(Ø15mm)

Green / Ground

Black / Hot

White / Neutral

Power supply

Cable to ﬁxture

Dim+purple(0-10V)

Dim-gray(0-10V)

Fig. 4

4. Place driver box into ceiling

Fig. 5

5. Press to eject ﬁxture cover

Fig. 6

Instructions

www.vonn.com

8. Connect the DC wire between ﬁxture body

and driver box. Place the DC wire into

hole cutout in ceiling. Secure ﬁxture body

to ceiling with screws