Installation Sheet

1. Cut (Ø5/8”) hole in the ceiling

(Minimum ceiling thickness 1/4”)

2. Pull building supply wires through

ceilling cutout and open ﬁxture box door.

Remove desired housing knockout and feed

building wires into housing using

appropriate connector.

Fig. 1

Fig. 2

3. Connect ﬁxture wires to building wires

Connect each supply wire with appropriate dirver wire

connector

ROUND: CUT OUT

Fig. 3

Ø5/8”(Ø15mm)

Green / Ground

Black / Hot

White / Neutral

Power supply

Cable to ﬁxture

Dim+purple(0-10V)

Dim-gray(0-10V)

Fig. 4

4. Place driver box into ceiling

Fig. 5

5. Press to eject ﬁxture cover

Fig. 6

Instructions

www.vonn.com

6. Connect the DC wire between ﬁxture body

and driver box. Place the DC wire into

hole cutout in ceiling. Secure ﬁxture body

to ceiling with screws

Installer tip: The ﬁxture features electric low voltage

(ELV or 0-10V) dimming capabilities.