Installation Sheet

1. Cut (Ø5/8”) hole in the ceiling
(Minimum ceiling thickness 1/4”)
2. Pull building supply wires through
ceilling cutout and open fixture box door.
Remove desired housing knockout and feed
building wires into housing using
appropriate connector.
Fig. 1
Fig. 2
3. Connect fixture wires to building wires
Connect each supply wire with appropriate dirver wire
connector
ROUND: CUT OUT
Fig. 3
Ø5/8”(Ø15mm)
Green / Ground
Black / Hot
White / Neutral
Power supply
Cable to fixture
Dim+purple(0-10V)
Dim-gray(0-10V)
Fig. 4
4. Place driver box into ceiling
Fig. 5
5. Remove fixture body cover by prying open with hex wrench
Fig. 6
6. Remove screw and take out mounting bracket
Instructions
© VONN Lighting,2020
www.vonn.com
Installer tip: Hex wrench is recommended; however, other
tools may be used.
Installer tip: The fixture features electric low voltage
(ELV or 0-10V) dimming capabilities.