Specifications

28 – 29Contents, specifications and availability are subject to change serving the technical improvement.Contents, specifications and availability are subject to change serving the technical improvement.
Head-up display
Keeping an eye on the speedometer and the road
at the same time: it’s possible with the WAECO
head-up display. The current speed is displayed on a
non-reflecting projection film in front of the windscreen –
right within the driver’s field of view.
A glance at the vehicle speedometer takes about one
second of your concentration. Say you are doing 100
km/h, that means you are driving 28 metres – blind!
These metres may be crucial in critical situations …
The system comes with an alarm function that can be
activated to warn you when preset speed limits are
exceeded. A convenience and safety feature that used
to be reserved to the luxury class. Now available for
retrofitting in WAECO quality.
The head-up display is easy to install and operate.
Keep an eye on your speed
Drive safely and with full concentration thanks to the WAECO head-up display
www.dometic-waeco.com
MagicSpeed
Note: If in doubt where to find the speedometer signal cable, contact our technical service team.
They can also advise as to whether or not you will need a signal amplifier for your vehicle.
WAECO MagicSpeed HUD 3.06
Head-up display for projecting the speed to the windscreen
With speed
warning function
Light sensor
automatically adjusts
LED illumination
Features & functions
› Displays current speed
› Speed warning function
(e.g. at 30, 50 or 70 km/h)
› 4 programming buttons
› Green LED lighting
› Speaker on top of the housing
to emit warning signal
› Grey housing
› 3-pole connection cable
(ignition, earth, speed signal)
› Single-coated projection film
› Light sensor – display illumination
dims as darkness sets in
› Voltage supply via ignition plus
Test mark E-approved to Automotive EMC Directive
Scope of delivery Head-up display, connection cable, projection film, installation fittings,
installation and operating instructions
Product Ref. No.
MagicSpeed HUD MHUD-100
Optional extra: signal amplifier MS-SV
Spare part: projection film MHUD-100PF
Luxury-class comfort at the touch of a button – programmed in 5 steps
1 Stand-by mode
The display is ready for service
as soon as you turn on the
ignition. All indicator lamps flash
for about two seconds.
2 Coarse adjustment
Adjust the speed readout of the
display to that of the speedo-
meter. To be done in four steps
(10, 20, 40, 80 km/h).
3 Fine adjustment
Adjust the speed readout of the
display to exactly that of the
speedometer. To be done in a
range from 50 to 250 km/h.
4 Set warning speed
Set at what speed limit the
display is to emit an audible
warning signal (eight stages,
from 30 to 130 km/h).
5 Warning tone
Naturally, you can also
disable the warning function.