Specifications

Volvo Trucks North America, Inc. Date Group No. Page
TSI 9.2003 211 007 26(41)
17
Draw the cover down evenly until the cylinder head and
cover are aligned. Tighten bolts in the proper sequence
and torque to 33 ± 3 Nm (24 ± 3 ft-lb).
33 ± 3 Nm
(24 ± 3 ft-lb)
18
Measure the cam sensor-to-pole wheel air gap.
Note: Make sure the air gap is between 0.3 – 0.7
mm (0.011 – 0.028 in.).
0.3 – 0.7 mm
(0.011 – 0.028 in.)
19
Connect the electrical cable to the cam sensor on
the cover.
20
T2007149
Fig. 28: Intake manifold
Apply an even 2 mm (0.08 in.) bead of sealant around
the intake manifold. Install the intake manifold and
connect the electrical wires.
CAUTION
The sealant must not harden before installing the
intake manifold. If the engine is equipped with a VEB,
make sure that sealant does not enter the oil channel
as this can negatively affect brake operation.
21
Install the turbocharger; refer to Service Information,
Group 25.
22
Adjust the valves and unit injectors. For the adjustment
procedure, refer to Service Information, Group 23.