Specifications

Volvo Trucks North America, Inc. Date Group No. Page
TSI 9.2003 211 007 21(41)
2154-06-03-02
Camshaft Timing, Check and Adjust
You must read and understand the precautions and
guidelines in Service Information, group 21, "General
Safety Practices" before performing this procedure.
If you are not properly trained and certified in this
procedure, ask your supervisor for training before
you perform it.
Special tools: 9996956, J-41272, J-42773
1
Note: Special tools with part numbers that begin with
“J” are available from Kent-Moore.
Remove the cam sensor
wheel.
2
Install the camshaft alignment tool J–42773 by inserting
the guide pin into the hole under the camshaft drive
gear. Rotate the tool to position the lever against the
drive gear teeth to ensure correct positioning of the
camshaft alignment tool.
3
T2012262
With J-42773 held in position, set the camshaft as shown.
Note: The camshaft setting must be exactly as illustrated
in the illustration. It is important that the camshaft gear
marking is positioned precisely on both sides of the tool in
a line extending from the center of the camshaft.
J-42773