Specifications

Volvo Trucks North America, Inc. Date Group No. Page
TSI 8.2003 215 001 7(21)
10
T2007148
Fig. 7: Tool 9998270 installed
Install camshaft counterhold tool 9998270 on the rear of
the camshaft. Loosen and remove the camshaft drive
gear center bolt and the cam gear.
9998270
11
Remove the camshaft cap bolts. Mark the caps for the
respective bearing housings, and remove.
Note: To facilitate the removal of the camshaft bearing
caps, use tool J–44457.
Note: Failure to match the correct camshaft cap with the
respective bearing housing will cause engine damage.
J–44457
12
C2000508
Fig. 8: Lifting the camshaft
Carefully lift off the camshaft using tool 9998264.
9998264
13
Remove the bearing shells from the bearing housings.
14
Inspect the bearings and housings for damage.
Note: When replacing the camshaft on the D12 engine,
remember that the bearing shells are available in different
sizes. Refer to Group 20, Specifications.