Specifications

Volvo 1990 760 Model
If the light in the air conditioning push button begins to flash when the ignition is switched on, a simple fault is indicated. The
system will compensate by substituting a standard value stored in the memory. System performance loss will be slight.
If the light continues to flash more than 20 seconds, a more serious fault is indicated. While the system will again attempt to
substitute a standard value, some reduction in system performance will become apparent. Contact your authorized Volvo dealer for
service.
pg. 25 Audio Cassette/Tuner controls and indicators
Operating instructions
For complete operating instructions, maintenance guidelines, and specifications, please consult your Audio Cassette/Tuner
Instruction Booklet. The Booklet also contains information on radio reception and the radio antenna.
Radio antenna mast
NOTE: Always lower the antenna mast when entering an automatic car
wash.
The antenna should be cleaned and lubricated every 5,000 miles (8,000 km).
Multipath Distortion
FM Signals are typically "line-of-sight", and very reflective. Their reflectivity to objects such as buildings, mountains, even other
passing vehicles, causes the condition known as multipath distortion. This distortion is the result of the reflected signal, and the
direct signal reaching your antenna at slightly different times causing a cancellation of all signals. This condition will sound like
hissing, or static. Very little can be done to eliminate this problem, however, lowering the treble on your radio could help mask
these disturbances thereby allowing you to achieve optimum pleasure from your audio system.
pg. 26 Front seats
Electrically operated front seats
The front seats are electrically operated. using the switches on the side of the seats you can adjust:
- the height of the seat (rear)
- the height of the seat (front)
- the forward-backward movement
- the backrest tilt
NOTE: The electrically operated front seats have an overload protector which engages if an object blocks either of the seats. If
this happens remove the object and wait 20 seconds. The overload protector should then have cooled down and the power seats
should function normally.
file:///K|/ownersdocs/1990/1990_760/90760_05.htm (4 of 5)12/30/2006 8:26:53 AM