Specifications

Rotary Dimming Controls
The missing link for gridplate systems
Level Select
Single channel brightness level selection
Level Select wallplate is a controller for a single-channel of
lighting, housed in a single-gang wallplate with various finish
options. A rotary knob selects between either one of four preset
levels and off (LS4), or one of two preset levels and off (LS2).
LEDs on the wallplate indicate the selection.
Light levels are preset on finger-turn adjusters on the back of the
plate and are tamper proof once the plate is installed.
Level Select wallplates are wired in 3-core cable carrying an
SELV low voltage signal, either to:
•
Multiload Analogue Mains Dimmer AD2500 (p11) for mains
dimmable loads, or
•
Multiload Contactor Controller MCC (p12) which provides a
0-10V signal to 0 -10V drive units for LEDs, fluorescents, etc.
These units switch and isolate the mains supply controlled by
the 3-core low voltage signal from the wallplate(s).
Features and benefits
•
Individual control and selection of pre-adjusted light levels
for a single channel of lighting.
•
Hard wired memory, no corruptible software.
•
Simple and safe manual adjustment of light levels:
no programming or commissioning.
•
Preset to set the brightness of the LEDs on the wallplate.
•
Preset to set fade time between levels from 1 – 10 secs.
•
For use as a system with AD2500 for all mains dimmable
lighting and MCC for all 0-10V drive units such as LEDs or
fluorescents.
Technical
•
Switches 10A when used with AD2500 and MCC
•
SELV compatible when using AD2500 and MCC
Finishes available
AB
ANTIQUE
BRASS
BMA
ANTIQUE
BRONZE
BL
BLACK
WH
WHITE
GO
GOLD
PB
POLISHED
BRASS
PS
POLISHED
STAINLESS
SS
SATIN
STAINLESS
SC
SATIN
CHROME
Product order codes
LS4/XX: 4 levels and off
LS2/XX:: 2 levels and off
(where XX denotes finish
specified – see below)
Rotary Dimming Modules combine 0-10V or 1 -10V rotary
potentiometer dimming with push on/off mains switching
in a single module.
Ideal for the drive units for energy saving light sources, such as
LEDs, fluorescents, low voltage, neon and argon.
Available as
•
Rotary Push Switch (RPS)
Direct control of drive units without additional hardware.
Mains switching and separate low voltage signal direct to
drive units.
•
Rotary Push Control (RPC)
For Retrofit and Multiple control positions.
Single 2-wire low voltage control of mains switching and
dimming: uses MCC (p12) and allows easy retrofit. Uses MTC
(p12) to provide multiple control positions around a room.
Energy saving light sources need dedicated drive units. Most
drive units accept a 0–10V or 1–10V analogue signal for dimming
the lighting. This new type of rotary dimming control provides
this signal for gridplate systems.
Modules clip into grid-plates from UK manufacturers including
MK GridPlus, Wandsworth Series 2 and 3, Hamilton, Forbes and
Lomax, Crabtree.
Rotary Modules (including the knob) come in a range of finishes
to match the chosen manufacturer’s gridplate. All manufacturer’s
gridplates and backboxes should be purchased directly from a
wholesaler. Multiload Technology can supply these items on
request if necessary.
6