Owner`s manual

Page 10
TRANSPORTING UNITS
All models with an “L” as the first letter have fuel
tanks with a shut-off valve located on the bottom of the tank. When
moving the unit, it is always recommended to turn the shut-off valve
(clockwise). This will prevent accidental spillage of fuel from the tank to
the carburetor float. Some “A” series models with fuel tanks mounted
directly on the engines do not have shut-off valves.
APPROXIMATE POWER
Requirements for Equipment
WATTAGE REQUIREMENTS
Starting Running
Battery charger, 10 amps - 200
Compressor (see motor charts) -3/4 HP 1900 850
-1 HP 2500 1100
-2 HP 3600 1800
-3 HP 4800 2400
Drill -1/4” 400 300
-3/8” 650 475
-1/2” 900 750
-1” 1250 1000
Welder 100 amps DC - 3600
Floodlight -- 1000
Grain cleaner, 1/4 HP 1000 650
Grain elevator, 3/4 HP 3000 1400
Grinders (by motor size)
Heater radiant portable -- 1300
Heater portable liquid fuel -50,000 btu 675 225
-100,000 btu 1260 420
-150,000 btu 1875 625
Impact wrench -1/2” 750 600
-3/4” 900 750
-1” 1400 1200
Milk cooler 1800 1100
Mixer, 3 ½ cubic feet 2300 1000
Motors-
Belt sander 2600 1200
Disc sander 2600 1200
Orbital sander 2600 1200
Chain saw 3400 1200
6” circular saw 2200 950
7 ¼” circular saw 2600 1200
8 ½” circular saw 3000 1500
10” circular saw 3900 2000
Jig saw 400 300
Cutoff saw 3500 2500
Screwdriver 800 550
Soldering iron or gun - 150
Sump pump 1300 400
Water pump submersible -3000 gph 1750 500
-5000 gph 2500 650
-10000 gph 3750 1000
-15000 gph 5000 1500
Water pump non submersible -3000 gph 2250 600
-5000 gph 2850 750
-10000 gph 4100 1100
-15000 gph 5250 1600
CAUTION
!