Owner`s manual

VANNER

Incorporated OWNER’S MANUAL

PMEC-12/24 OWNER‟S MANUAL

Troubleshooting

CAUTION

Servicing of electrical systems should only be performed by trained and qualified technical personnel.

Equipment Required

VoltMeter having 0.01 volt resolution. (Fluke Model 87 Multimeter recommended).

Clamp-on current meter (Fluke Model 36 Clamp-on Meter recommended).

USB to CAN adapter module - PEAK System‟s PCAN-USB IPEH-002021 or

Vector‟s CANcaseXL V2.0 w/CANpiggy 1050mag installed

Laptop computer with Vanner CAN interface software.

Vanner Repair Service

Vanner offers a quick turn-around factory repair service. Send the unit to the address on last page with a

note instructing us to repair it. Include your name, phone number, shipping address (not a P.O. Box

Number), and your purchase order number.

Trouble Shooting Guide for PMEC

PMEC-12/24 Trouble Shooting Guide:

In the event the Vanner PMEC does not work properly, the following need to be reviewed / validated;

1. Is voltage present at the 100A input terminal? This can be verified with a voltmeter or by checking

that the green “Power” led is lit.

2. Is the I/O wiring installed correctly? (Reference pin-out assignments on page 15.)

3. Is the current sensor installed in the proper orientation? (Reference wiring diagrams on pages 17 -

19.)

4. Is the voltage / temperature sensor installed on the proper battery terminal? (Reference wiring

diagrams on pages 17 - 19.)

5. Are the fuse voltage and current ratings correct?