Owner`s manual

VANNER Incorporated OWNER’S MANUAL
PMEC-12/24 OWNER‟S MANUAL
11
PMEC States
AutoStart is enabled
Engine Start is on (LED on dash mounted remote will be on)
Loads A and B will be switched “on”
5 – Fast Idle
This state represents the condition the PMEC will be in while the engine is running in the fast idle
mode during a battery recharge cycle. The engine will enter the fast idle mode if the battery voltage
(Vbatt) is less than the alternator maximum voltage (AltMaxVoltage) – 0.5 and the battery current
(Ibatt) is less than or equal to the fast idle current (FastIdleCurrent) setting. The following are the
vehicle conditions in this state;
1. Ignition in “on” position
2. Gear selector in park position
3. Hood closed
PMEC States
AutoStart is enabled
Engine Start is on (LED on remote will be on)
Fast idle mode is active (LED on remote will be on)
Loads A and B will remain “on”
6 – Load Cutting
This state represents the condition the PMEC will be in while in the “load cutting” mode. The “load
cutting” mode can be entered from any of three modes, “auto start”, “engine start” and “fast idle”. If
the state of charge achievable (SOCach) value is less than or equal to the state of charge load off
(SOC_LoadOff) value, the PMEC will automatically turn loads A and B off to accelerate the
recharging of the batteries. Once the state of charge achievable (SOCach) value is greater than the
state of charge load off (SOC_LoadOff) value, the PMEC will return to the appropriate state. The
following are the vehicle conditions in this state;
1. Ignition in “on” or “off” position
2. Gear selector in park position
3. Hood closed
PMEC States
AutoStart is enabled
Engine Start is either on or off depending on state it was in prior to entering “load cutting” mode
Fast idle mode is active (LED on remote will be on)
Loads A and B will be switched “off”
7 – Hood Open
This state represents the condition the PMEC will be in upon opening the hood while it is in state 1, 4
or 5. The following are the vehicle conditions in this state;
1. Ignition in “off” position
2. Gear selector in park position
3. Hood open
PMEC States
AutoStart is disabled
Engine Start is off
Fast idle is off
Loads A and B will be switched “off”
Upon closing the hood, the PMEC state will return to the initial settings found in state 0.