User manual

Voltsoft User Manual Version 2.0
82
6.8.4 DL191V – Settings
1 Time Configure the device data time value.
The user can specify a defined time or use the system
date time.
2 Logger Name Input the unique alias for that device.
3 Record Start Condition By Button – The data logger will start recording only
after the user pressed the red button on
the device.
After Setup – The data logger will start recording
immediately after setup.
4 Sample Points Configure the data logger sample points.
5 Sample Rate Instruct the data logger to log readings at a specific
rate.
6 Record LED Flash Configure the LED flash cycle - the longer the time, the
longer the battery life.
7 Enable LED Alert Enable / disable LED flash when the alarm is triggered.
8 Low / High Alarm Configure the low / high alarm level for voltage.
9 Default Button Load the factory default settings.
10 Setup Button Save changes.
11 Close Button Close this interface.