User manual

Voltsoft User Manual Version 2.0
63
6.5.4 DL181THP – Settings
1 Time Configure the device data time value.
The user can specify a defined time or use the system
date time.
2 Logger Name Input the unique alias for that device.
3 Record Start Condition By Button – The data logger will start recording only
after the user presses the red button on
the device.
After Setup – The data logger will start recording
immediately after setup.
4 Sample Rate Instruct the data logger to log readings at a specific
rate.
5 Sample Points Configure the data logger sample points.
6 Recording Time Calculate the recording time based on the selected
sample points and sample rate.
7 Altitude Allows user to set the current altitude.
8 Record LED Flash Configure the LED flash cycle - the longer the time, the
longer the battery life.
9 Enable LED Alert Enable / disable LED flash when the alarm is triggered.
10 Temperature Low / High
Alarm
Configure the temperature low / high alarm level
11 Humidity Low / High Alarm Configure the humidity low / high alarm level
12 Air Pressure Low / High
Alarm
Configure the air pressure low / high alarm level
13 Default Button Load the factory default settings.
14 Setup Button Save changes.
15 Close Button Close this interface.