User manual

Voltsoft User Manual Version 2.0
49
6.3.4 DL141TH – Settings
1 Device Time Configure the device data time value.
User can specify a defined time or use the system date
time.
2 Logger Name Enter the unique alias for that device.
3 Record Start Condition By Button – The data logger will start recording only
after the user presses the red button on
the device.
After Setup – The data logger will start recording
immediately after setup.
Sample Rate Instruct the data logger to log readings at a specific
rate. The user can input specific data in the edit box on
the left and select the time unit using the combo box
on the right.
5 Recording Time Calculate the recording time based on the selected
sample points and sample rate.
6 LED Flash Cycle Configure the LED flash cycle - the longer the time, the
longer the battery life.
7 Recording Instruct the data logger to continue logging data,
recording over the earlier data (Circulating Record), or
to stop logging (No Circulating) when the data logger
memory is full.
8 Enable LED Alert Enable / disable LED flash when the alarm is triggered.
9 Temperature Low / High
Alarm
Configure the temperature low / high alarm level.
10 Humidity Low / High Alarm Configure the humidity low / high alarm level.
11 Default Button Reload the factory default settings.
12 Setup Button Save changes.
13 Close Button Close this interface.