User manual

Voltsoft User Manual Version 2.0
37
6.1.4 DL101T - Settings
Note: Any stored data will be permanently erased when setup is finished.
1 Time Configure the device data time value.
The user can specify a defined time or use the system
date time.
2 Logger Name Input the unique alias for that device.
3 Record Start Condition By Button – The data logger will start recording only
after the user pressed the red button on the device.
After Setup – The data logger will start recording
immediately after setup.
4 Sample Points Instruct the logger to take a finite number of readings.
5 Sample Rate Instruct the logger to log readings at a specific rate.
6 Recording Time Calculate the recording time based on the selected
sample points and sample rate.
7 LED Flash Cycle Configure the LED flash cycle - the longer the time, the
longer the battery life.
8 Enable LED Alert Enable / disable LED flash when the alarm is triggered.
9 Temperature Low / High
Alarm
Configure the temperature low / high alarm level.
10 Default Button Reload the factory default settings.
11 Setup Button Save changes.
12 Close Button Close this interface.