User manual

Voltsoft User Manual Version 2.0
121
Command Button
Manual Range Click to send commands to make device entering the
manual range.
Auto Range Click to send commands to make device entering the
auto range.
MAX / MIN / AVG Click to send commands to enable maximum, minimum,
average function.
Exit Max Click to send commands to exit maximum, minimum,
average function.
NG Beep In the COMP VALUE mode, if failed, click button to turn
the alarm on/off.
Light Click to send commands to enable device backlight
function, and then click the exit functions.
Select Click to send commands to enable device function
selection.
Hold Click to send commands to enable device to maintain the
function, and then click to exit maintain function.
REL Click to send commands to enable the relative value
function; then click to exit the function.
Pass Beep In the COMP VALUE mode, if passed, click button to turn
the alarm on/off.
COMP Value Enter / Leave COMP value mode.
COMP Setting Pop up Data Comparison dialog.
Single Log Click to send commands to enable device to store a
single data.
Series Log Click to send commands to enable device to continuously
store data, and then click to exit the function.
Load Comparison Memory Click to send commands to send out the comparison data
stored by device.
Clear Comparison Memory Clear the comparison data in device.
Load Device Memory Click to send commands to send out the no comparison
data stored by device.
Clear Device Memory Clear the no comparison data in device.
Data Comparison dialog
Setup Enter When button is pressed, the upper/lower limit and the mode can be modified;
when button is up, the settings will be sent and saved in the device.