User manual

Voltsoft User Manual Version 2.4
176
6.21.8 VC890 – Data View
VC890 contains many different measurements, you will need to specify which measurement
(and unit) to download in “Display / Plot data” dialog.
1
Record / Display
Button
Use these two buttons to toggle between display and record
mode.
In display mode, the reading measured by the device will
be displayed in the display area.
In record mode, the reading measured will not only display
in the display area, but also be stored in the database for
future use.
N.B.
i) If the device is in record mode this means it is also in
display mode.
ii) Stopping the display mode will also stop the record
mode.
2
Command Button
Refer to below section.
3
Display Area
Display the measured value.
4
Back to real time
mode
This button will be displayed when the device is in real time
mode but the interface is not showing real-time data (e.g.
downloading log data / historical data).
Clicking this button can return the interface to displaying
real-time data.
Command Button
Manual Range
Click to send commands to make device entering the
manual range.
Auto Range
Click to send commands to make device entering the
1
2
3
4