Instructions

34
17. Troubleshooting
In purchasing the Energy Logger 4000, you have acquired a product which has been designed to the state of
the art and is operationally reliable.
Nevertheless, problems or faults may occur. For this reason, the following is a description of how you can
eliminate possible malfunctions yourself.
Please always observe the safety instructions!
Error Possible cause Remedy
Data transmission to SDHC
card does not start
The card symbol is not in the display. Insert the card until end of the card
slot.
Thecardsymbolisashing.Thecard
is full or does not correspond with the
requirements (size, format).
Loosen the card or replace it.
No operation possible. You are mode „Data transmission“. After the end of the data tranmissions
remove the SDHC card from the
measurement device.
No data memor any more
available (MEM < 2%).
The internal data memory is full. Back up the data on a SDHC card
and delete the data memory.
Repairs other than those just described should only be performed by an authorised specialist.
Our technical support is happy to answer any questions you might have about using the measurement
device.