User manual

Regularly check the technical safety of the instrument and measuring cables,
e.g. check for damage to the housing or crimping etc.
Never operate the device when it is open! !RISK OF FATAL INJURY!
Do not exceed the maximum permitted input values. Never touch circuits or
parts of circuits with voltages greater than 25 V/AC rms or 35 V/DC! Risk of
fatal injury!
UNPACKING
Check all the parts for completeness and damage after unpacking.
Damages parts must not be used for safety reasons. In case of any damage
contact our customer service.
SETTING UP THE DEVICE
Set up the device, using the handle or the device’s pedestal,l so it can be operated and read •
comfortably.
Avoid direct sunlight over long periods, since it could damage the screen.•
In order to comply with the technical tolerance data, the device has to be operating for
about 30 minutes within the given operating temperature range.
GETTING STARTED
Connect the mains cable provided to the mains connector, at the back of the device, and 1.
connect the Schuko plug to an earthed mains socket.
Switch on the device with the power switch (POWER I/0).2.
The device shows a start screen and is ready for operation after a short initialisation phase.3.
Connect the appropriate measuring cables/probes to the BNC connector of the input 4.
channel(s) 1 or/and 2.
The measuring voltage should only be applied to the internal conductor.
The external conductor (reference earth) is connected to the earth potential
(protective earth conductor).
Touch the object to be measured with the probes.5.
To automatically set the signal, push the button AUTOSET. This function sets the time base, 6.
theverticaldeectionandthetriggerlevelautomaticallytooptimisethesignalvisualisation
on the oscilloscope.
Removetheprobefromtheobject,afternishingthemeasurement,andturnoffthedevice.7.
CLEANING
Always observe the following safety instructions before cleaning the device:
Live components may be exposed if covers are opened or parts are removed
(unless this can be done without tools).
Prior to cleaning or repairing of the device, all cables have to be detached and
the device has to be turned off.
Do not use scouring, chemical or aggressive cleaning agents such as benzene, alcohol •
or such like. These might attack the surface of the device. Furthermore, the fumes are
hazardous to your health and are explosive.
Moreover, you should not use sharp-edged tools, screwdrivers or metal brushes or suchlike •
for cleaning.
For cleaning the device or the display and the measuring cables, use a clean, slightly damp, •
fuzz-free, antistatic cloth.
Should questions arise concerning the use of the device, feel free to contact
our technical support at the following phone number:
Voltcraft®, D-92242 Hirschau, Lindenweg 15,
Tel. +49 180 / 586 582 7
DISPOSAL
Electronic devices are recyclable waste and must not be disposed of in the household
waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
Legal notice
These operating instructions are a publication by Voltcraft®, Lindenweg 15, D-92242 Hirschau/Germany, Phone [phone]
(www.voltcraft.de).
Allrightsincludingtranslationreserved.Reproductionbyanymethod,e.g.photocopy,microlming,orthecaptureinelectronicdataprocessing
systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2011 by Voltcraft® V1_0811_02-SB