User manual

Using the probe compensation signal

Background This section introduces how to use

the probe compensation signal for

general usage, in case the DUT

signal is not available or to get a

second signal for comparison. For

probe compensation details, see

page 135.

Note that the frequency accuracy and duty factor are not guaranteed. Therefore

the signal should not be used for reference purpose.

Waveform type

Square waveform used for probe

compensation. 1k ~ 100kHz, 5% ~ 95%.

Demonstration signal for showing

the effects of peak detection. See page

78 for peak detection mode details.

View the probe

compensation

waveform

1. Connect the probe between the compensation signal output and Channel

input.

2. Press the Utility key.

Utility

3. Press ProbeComp.

ProbeComp