Manualshelf

User manual

ManualsBrandsVOLTCRAFT ManualsLaboratory Test EquipmentDigital 150 MHz 2-channel 1 null 1 null 8 Bit Digital storage (DSO)
21222324252627282930
21
Setting up the Oscilloscope
Background This section describes how to set up the oscilloscope properly including adjusting
the handle, connecting a signal, adjusting the scale, and compensating the
probe. Before operating the oscilloscope in a new environment, run these steps
to make sure the oscilloscope is functionally stable.
Procedure
1. Pull both bases of the handle out
slightly.
2. Turn to one of the three preset
positions.
3. Connect the power cord.
4. Press the power switch. The
display will become active in
approximately 10 seconds.
5. Reset the system by recalling the
factory settings. Press the Save/
Recall key, then Default Setup.
For details regarding the factory
settings, see page 45.
Save/Recall
Default
Setup