User manual
11
(Pollution Degree) EN 61010-1:2001 species pollution degrees and their
requirements as follows. The oscilloscope falls under degree 2.
Pollution refers to “addition of foreign matter, solid, liquid, or gaseous (ionized
gases), that may produce a reduction of dielectric strength or surface resistivity”.
• Pollution degree 1: No pollution or only dry, non-conductive pollution occurs.
The pollution has no inuence.
• Pollution degree 2: Normally only non-conductive pollution occurs. Occasionally,
however, a temporary conductivity caused by condensation must be expected.
• Pollution degree 3: Conductive pollution occurs, or dry, nonconductive pollution
occurs which becomes conductive due to condensation which is expected. In
such conditions, equipment is normally protected against exposure to direct
sunlight, precipitation, and full wind pressure, but neither temperature nor
humidity is controlled.
Storage
environment
• Location: Indoor
• Storage Temperature: -10°C~60°C, no condensation
• Relative Humidity: 93% @ 40°C
65% @ 41°C ~60°C