User manual

103

10. Press Noise Rej to turn the noise rejection on or off.

Range On, Off

Noise Rej

Off

11. Press Previous menu to go back to the previous

menu.

Manually triggering the signal

Note This section describes how to manually trigger the input signals when the oscil-

loscope does not capture them. This section applies to the Normal and Single

trigger mode, since in the Auto trigger mode, the oscilloscope keeps updating the

input signal regardless of the trigger conditions.

To acquire the

signal regarless

of trigger

conditions

To acquire the input signal regardless of the trigger

condition, press the Force key.

The oscilloscope captures the signals once.

FORCE

In the Single

trigger mode

Press the Single key to start waiting for the trigger

condition. To break out of the Single mode, press the

Run/Stop key. The trigger mode changes to the

Normal mode.

SINGLE

Run/Stop