Manualshelf

User manual

ManualsBrandsVOLTCRAFT ManualsLaboratory Test EquipmentDigital 70 MHz 2-channel 250 null 4 null 8 Bit Digital storage (DSO)
919293949596979899100
93
Rear Panel USB Port Interface
The Remote control interface section describes how to set up the USB interface for PC connection.
The details of remote control commands are described in the VDO-2000 Series Programming
Manual.
USB connection PC end Type A, host
VDO-2000 Series end Type B, slave
Speed 1.1/2.0 (full speed)
Procedure
1. Connect the USB cable to the USB slave port on
the VDO-2000 Series.
2. When the PC asks for the USB driver, select dso_vdo.inf which is
downloadable from the Conrad website www.conrad.com.
3. On the PC, activate a terminal application such as MTTTY (Multi-Threaded
TTY). To check the COM port No., see the Device Manager in the PC. For
WindowsXP, select Control panel → System → Hardware tab.
4. Conguring the command interface is completed. Refer to the programming
manual for the remote commands and other details.