User manual

56
V Volt (unit of electrical voltage)
A Ampere (unit of electrical current strength)
mA Milliampere (=0.001 A)
µA Microampere (=0.000001 A)
Hz Hertz (unit of frequency)
kHz Kilo Hertz
MHz Mega Hertz
VA Voltampere (unit of apparent electrical power)
% Percentage display for duty cycle measurement
ºC Degrees Celsius
ºF Degrees Fahrenheit
Ω Ohm (unit of electrical resistance)
kΩ Kilo Ohm (=1000 Ω)
MΩ Mega Ohm (=1000000 Ω)
nF Nanofarad (unit of electrical capacitance = 0.000000001 F)
µF Microfarad (=0.000001 F)
mF Millifarad (=0.001 F)
Symbol for the capacitance measurement range
Warning symbol for voltages >30 V/AC and >42 V/DC
0 1 2 3 4 5 6
Bargraph display (only for V, A, Ω)
Low pass lter for alternating voltage
Low imp function
9. BATTERY
Before you can work with the measuring device, you must rst insert the enclosed
battery.
a) Inserting and replacing the battery
A 9 V alkaline or lithium monobloc battery is needed to operate the measuring device. When using
for the rst time or when the battery status symbol (at) appears in the display, you must insert a
new, full (rechargeable) battery of the same type. Also note the safety guidelines for (rechargeable)
batteries (page 53).