Information

113 0x71 Set APO Time：30 min NO
114 0x72 Set APO Time：off min NO
94 0x5e PC→VC890 Send Current Value NO
98 0X62 Enter Data Log Set (SET MENU 3) NO
99 0X63 OLED Display Off After 5mins’ Data Log NO
100 0X64 OLED Display On After 5 mins’ Data Log NO
101 0X65 Memory Type: FIX NO
102 0X66 Memory Type: OVERWRITE NO
103 0X67 Continuous Sample Time YES
104 0X68 Exit Data Log Set (SET MENU 3) NO
105 0X69 Enter Other Set (SET MENU 4) NO
106 0X6A OLED Brightness Level 1 Enabled After 15 Seconds’
Inactivity
NO
107 OX6B OLED Brightness Level 1 Disabled After 15 Seconds’
Inactivity
NO
108 OX6C Battery Type: Alkaline NO
109 0X6D Battery Type: LI-AKKU NO
110 0X6E Exit Other Set (SET MENU 4) NO
00 0x00 Get Device ID No
01 0x01 SET_COMP_MODE_ALL Yes
02 0X02 Comp Data No
03 0X03 GET SETUP Data No
255 0xFF Result Yes
To setup the comparison value at the DMM, please follow the following sequence:
1) DMM must be at the COMP mode,
2) Send “SET_COMP_ENTER” command to enable the change of the COMP value
3) Send the following command to change the COMP mode value
a) “SET_COMP_MODE_HIGH_VALUE”
b) “SET_ COMP_MODE_LOW_VALUE”
c) “SET_COMP_MODE_INNER”
d) “SET_COMP_MODE_OUTER”
e) “SET_COMP_MODE_ALL”
4) Send “SET_COMP_ESC” when finish changing the COMP mode value
4.1 SET_COMP_MODE_HIGH_VALUE
This message contains the high value of the comparison mode. The high value is represented in ASIC-II format.